Евгений, я в этом деле нович0к.
Этой программой что то проверил – i1Diagnostics
Device Information
Device type: i1Pro (NO filter) [ Ambient Light Emission Reflectance Reflectance Scan Flash ]
Serial number: 304685
Firmware version: 502
CPLD version: 999
Dark measurement count: 3630
Lamp burning time: 1220.86 seconds
Spot measurement count: 226
Scan measurement count: 371
Dongle Test
Module “Scanner” is not licensed
Module “Monitor” is licensed
Module “Printer” is not licensed
Module “Printer RGB only” is not licensed
Module “Printer CMYK only” is not licensed
Module “Beamer” is not licensed
Module “Printer Easy RGB” is licensed
Module “Printer Easy CMYK” is licensed
Module “Digicam” is not licensed
Module “Editor” is not licensed
Button Test
Button is not working or was not pressed
*** FAIL ***
А что там к чему-посмотри. Через прогу ProfileMaker наверно можно калибровать (судя по кнопкам)-принтер, сканер, камера, монитор, MULTIKOLOR (это для проверки чего?), device link (что за кнопка-два принтера и стрелками связаны, перевел как связь устройства)
Но глядя на “is not licensed”, не всё будет доступно?